2033 FA 1.6 SIM Complete - Next SIM Sunday evening 03/16

[Guest]

When you run extractor, it produces a .csv file which you then load using draft analyzer.

CSV just means comma separated values; it's just plain text. Make a backup in case it goes wrong, but once you edit it, you save the file and load into DA as before.

Actually, reading on FOFC, it sounds like you'll be needing to "find" this:

"LS",""

and replace all with this:

"C","C"

....but I'm not sure.

FTFY. Greg will be updating DA to work with the new export data so we won't have to do this in the future.

For now, however, without editing the csv you can still use DA, when the error pops up just hit continue and use as you normally would. You can't save or anything, but you can still use DA.

[sawblade300]

FTFY. Greg will be updating DA to work with the new export data so we won't have to do this in the future.

For now, however, without editing the csv you can still use DA, when the error pops up just hit continue and use as you normally would. You can't save or anything, but you can still use DA.

This is what used to happen and I did this, but now, you can't even load the exported class into DA.

This is what I get:




Do I have to edit one of these categories?

[Aston]

Saw, it looks like you haven't run extractor on the class to begin with.

We're talking about StelmackSuite's Extractor on the draft class, which should run as before. That looks like you ran interrogator or omething.

[sawblade300]

I swear it was extractor. I've done it dozens of times. I suppose I could have hit the wrong button. I will try again.

Edit: I just double checked and I did run extractor. I've done it in two leagues now and I get that screen each time I hit "Load extractor output". Just like I always have. I'm just very confused right now

[Aston]

Oh, well, in that case, you just need to find where the extractor output file is, navigate to that directory, and open it up.

Someone with better memory can probably tell you where extractor puts its output file and what it's called.

(edit: it looks like DA is opening up the Stelmack install directory by default. The extractor csv is probably located within the Documents\Stelmack... directory. )

(further note: by default, DA will open up whatever directory it last tried to open a file from.)

[Guest]

If you could take a screenshot with Extractor open then we can answer where everything is going.

[sawblade300]

I found it. Somehow when I extracted the class, the .csv file went into my documents under stelmack. So I get it from there and I'm all good. Thanks for all the help guys.

[sawblade300]

Oh, well, in that case, you just need to find where the extractor output file is, navigate to that directory, and open it up.

Someone with better memory can probably tell you where extractor puts its output file and what it's called.

(edit: it looks like DA is opening up the Stelmack install directory by default. The extractor csv is probably located within the Documents\Stelmack... directory. )

(further note: by default, DA will open up whatever directory it last tried to open a file from.)

Yup yup. That's where it was.